Author: Youth Performance Motorsports June 16, 2008 at 20:27:30 from 12.216.56.126
I HAVE AN ARRAY OF SMALL BLOCK STUFF TO BUILD SEVERAL MOTORS AND WANT TO TRADE IT FOR A COMPLETE BIG BLOCK,MUNCIE TRANS, AND SHIFTER......
It consist of Lunati 4340 hooters cup 37 pound crank-crank was 2700.00, Carrillo 6inch rods with forced pin oiling with the high dollar Carr bolts, rods&bolts alone were about 3500.00, enough JE 4.00-4.60 pistons for several motors with valve reliefs for around 800 lift and compression with 58 cc head in the 15+ range-pistons were custom with all the frills for hooters cup 18&23 degree head motor and they were around 1300.00 a set, an excellent set of pro comp heads that have been ported by Shwanakee racing engines in Minnesota and are brand new, full roller set-up with brand new in the box comp lifters,custom PSI full polished valve springs which cost in the area of 900.00, Bowtie intakes,MSD ignition systems, Moroso electric water pump, the list goes on.The parts would easily make in the 700 horse power range depending on timing, rocker ratio and fuel. I need some 392 Hemi parts and one excellent big block Chevy for my 69 Chevelle with a Muncie and Hurst comp plus shifter that will fit my console. All I want to do is drop it in and go, not looking for a killer 900 horse motor but a very nice 550-600 horse low hour piece would be good for a street car. Also need a good set of 69 SS wheels. LET ME KNOW WHAT YOU HAVE
Post Followup
Note: Follow-ups should only be used for information of interest to all viewers. For other inquiries or personal communication please send an email if possible or use other contact information provided.
When you return to the board you will need to do a REFRESH or RELOAD to see your followup.
